I found out that using a custom order of sensor in HWinfo and moving the sensor I read from at the very top of the list will prevent this from happening.īeta Was this translation helpful? Give feedback. This will happen if the added or removed sensor is over (on top) of the one FanControl is reading from in HWinfo list. if a sensor is added, removed or hidden in HWinfo while running), FanControl will returrn an incorrect or NaN reading and the fans associated with that sensor will ramp up or stop. Note2: This plugin rely on the order of the sensors listed in HWinfo, meaning if the order of sensor changes in HWinfo (ex. This has nothing to do with FanControl as it is a limitation of HWinfo free version. Furthermore, unless you use the paying version of HWinfo (PRO) the feature will deactivate itself every 12hrs. You will need to activate it in HWinfo (settings, General/ user interface tab). Note: This plugin rely on a feature of HWinfo called 'Shared memory support'. You are receiving this because you were mentioned.While fancontrol is closed, unzip the files from the zip in the plugin folder of Fancontrol, if needed, unblock the dll (see here), start fancontrol, activate the plugin in the sensor menu (top right 3 dots), refresh sensors (you might need to restart FanControl). Then watch your fans IRL as you slide each to figure out which is which.

Just assign a curve to the appropriate control, it should work.

On Jun 3, 2022, at 12:41 PM, Rem0o wrote:īut you mentioned the fans stopped during detection right? Don't bother with the speed cards with RPM, or any of the 'detected' stuff from the assisted setup. You are receiving this because you were mentioned.Message ID: from my iPhone If you can see your fans changing speed, then you're all good. On Jun 3, 2022, at 7:20 AM, Rem0o That's because since you got multiple fans on the same channel, the RPM detection is bust, so it can't rely on it. You are receiving this because you authored the thread.Message ID: from my iPhone It reads its configuration from a file, then calculates fan speeds from temperatures and sets the corresponding PWM outputs to the computed. Reply to this email directly, view it on GitHub, or unsubscribe. Provided by: fancontrol3.3.4-2ubuntu1all NAME fancontrol - automated software based fan speed regulation SYNOPSIS fancontrol configfile DESCRIPTION fancontrol is a shell script for use with lmsensors. And is the Mobo Controller set to the Right DC or PWM Control on SYS_Fan 1 corresponding to your Fans Ans what Connection do ther Use 3 Pin DC Control or 4 Pin Pwm Control. On Jun 3, 2022, at 7:13 AM, Audipower wrote:Ĭan you Control this Fans with the Mobo Settings in Bios ? Some Case fans are 1 Speed Only.

Instal the new for ios FanControl v164